Motion sensor CH-s04

umination. Thanks to many miniature lenses, it divides the detection area into 80 zones and is able to catch even the slightest movement at a distance of up to 10 meters and a triggering angle of 100 °. The sensor is well protected from various kinds of interference, which ensures high reliability and resistance to false positives. The miniature size of the sensor allows it to be almost invisible on any surface. The recommended installation location for the sensor is the ceiling. But if necessary, it can be placed in any convenient place for this. Do not place the CH-S04 sensors in places where the temperature changes rapidly. This will lead to false alarms of the sensor, and the sensor will not be able to detect the appearance of a person in the controlled area. 2. Manufacturer's warranty Warranty period - 1 year from the date of sale. Products that were transported, stored, installed and operated in violation of the requirements for these products, as well as having mechanical damage, are not subject to warranty replacement. Do not use the device in any way other than those specified in this manual. The manufacturer does not bear warranty obligations in case of non-compliance with the rules of operation, changes in the design or painting of the device. Immediately after opening the package, be sure to check the device for damage. If there is visible damage, do not connect or use the device. 3. Specifications Nominal supply voltage* 3.3 V Operating temperature range (prevent freezing of condensate at low temperatures) –20°C to +60°C Motion sensor viewing angle 100° ? 82° Detection diameter when installed at a height of 2.5m 10 m Maximum distance to the object of detection 10  m Minimum difference between the background temperature and the detected object ±4С° Illumination measurement range 0 - 4000Lx Maximum wire length (in case of extending the wire supplied with the sensor) 50 m Data transfer interface (data bus) S-Bus Degree of protection IP-43 Power supply provides the ConnectHome device to which the sensor is connected. If the length of the sensor wire is more than 2 meters, use the type of cable - twisted pair (Figure 3). 4. Installing and connecting the sensor The recommended installation location for the sensor is the ceiling. But if necessary, it can be placed in any convenient place for this. Do not place the CH-S04 sensors in places where the temperature changes rapidly. This will lead to false alarms of the sensor, and the sensor will not be able to detect the appearance of a person in the controlled area. The CH-S04 sensor is connected to a special S-Bus connector, which is located on some ConnectHome devices. In the Z-Wave network, the sensor is displayed as a structural unit (endpoint) of the module to which it is connected. Data is transmitted to the control controller using Z-Wave radio commands. The sensor must be connected before adding the device to your Z-Wave network.